We are giving you an opportunity to purchase 1lt Lithofin MN Colour Intensifier
at only £32.00Incl Vat
Improves the appearance of rough, absorbent natural and artificial stone surfaces. Invigorates the colours and accentuates the structure, makes water and dirt repellent.
• Ready for use • for indoor and outdoor use • no gloss • contains solvents • can be applied in several coats • ideal for concrete slabs
Description
A special product from the LITHOFIN-Range for marble,
natural and engineered stone (MN). This ready-to-use
siloxane impregnator is solvent based and contains special
colour intensifying components.
Technical Data:
Density: approx. 0,85 g/cm³
Appearance: liquid, colourless, clear
Odour: aromatic
pH-Value: n.a.
Flash Point: >25°C
Solubility in Water: not soluble
Properties
Lithofin MN Colour Intensifier penetrates into the surface
rendering it water repellent while at the same time
intensifying the colour without producing any gloss.
Surfaces appear more colourfull and fresh – wet effect. The
water resistance reduces the sensitivity of the surface,
largely preventing staining and facilitating maintenance.
Lithofin MN Colour Intensifier does not form any layers,
thereby maintaining the surfaces water permeability. The
slip resistance of the surface is hardly affected.
Durability: indoors and with correct maintenance nearly
unlimited. Outdoors, depending on the type of stone, the
colour will remain for approx. 1 to 2 years, the protective
effect for approx. 5 to 7 years. Can be reapplied when the
effect fades.
Field of Use
For adding lustre to wall and floor surfaces, stairs, entrance
areas, terraces, etc. which appear bland and colourless.
Suitable for indoor and outdoor use.
Surfaces: all absorbent, porous natural stones (e.g. granite,
gneiss, porphyr, marble, limestone, slate, etc.) and
engineered stones with rough, sawn, honed and flamed
surfaces.
Please Note: for protecting polished and very finely honed
natural and artificial stones, we recommend Lithofin
STAINSTOP >W<, Lithofin MN Stain-Stop or Lithofin
SPLAS-STOP.
Directions for Use
The surface to be treated must be completely dry and clean.
Where no prior experience exists or in cases of doubt, try
the product in an inconspicuous area prior to use. Evenly
apply a consistent amount of Lithofin MN Colour Intensifier
with a brush, a roller or a cloth. On highly absorbent
surfaces, this procedure may have to be repeated after five
minutes. Do not allow the surface residues to dry. Residues
must be completely removed within ten minutes with a cloth.
On large surfaces, remove the residues with a squeegee
and polish with a white pad.
Attention! treat only completely dry surfaces (drying time for
newly laid surfaces up to 8 weeks, otherwise several days).
Non-absorbent surfaces such as polished or fired materials
such as porcelain or ceramic tiles can not be treated. Glass,
wood, plastics and other surfaces sensitive to solvents must
