We are giving you an opportunity to purchase 1lt Lithofin Anti-Slip at only £32.00Incl Vat
Reliable slip resistance on slippery and wet floors, in shower recesses and bathtubs. Microscopic changes in the surface structure produce significantly increased slip resistance with a long term effect.
• Set for 6m² of safety • suitable for indoor and outdoor use
Description
The Lithofin Anti-Slip Set consists of a Basic Cleaner and
the Anti-Slip Fluid.
This set is suitable for making slippery ceramics, enamel
and natural stone surfaces slip resistant.
Basic Cleaner: mildly alkaline for removing oily and greasy
dirt from ceramics and natural stone.
Technical Data:
Density: ca. 1,0 g/cm³ pH-Value: ca. 10
Appearance: liquid, yellowish Odour: non-specific
Solubility in Water: complete
Anti-Slip: fluorid containing product for roughing ceramic
and natural stone surfaces.
Technical Data:
Density: ca. 1,0 g/cm³ pH-Value: ca. 3
Appearance: liquid, red Odour: non-specific
Solubility in Water: complete
Properties
The Lithofin Anti-Slip Fluid chemically reacts with the
surface of ceramics, enamel and silicate containing natural
stones. The product etches small cavities into the surface,
therby increasing the slip resistance.
Field of Use
For rendering surfaces slip resistant. Especially suitable for
porcelain, glazed ceramics, enamel and natural stone such
as granite, gneiss, etc. This treatment also works on wet
surfaces.
Directions for Use
1. Preparation: the surface must be thoroughly cleaned.
Dilute Lithofin Basic Cleaner up to 1:5 with water and apply
with a sponge. Vigorously scrub the surface with the rough
pad on the sponge. Carefully rinse the clean surface with
plenty of water to remove all product residues.
2. Treatment: first try the product in an inconspicuous area
in order to evaluate the effect and determine the working
time. Apply Lithofin Anti-Slip to the clean and dry surface
and immediately distribute the product evenly with the
second sponge (wear the enclosed protective gloves).
There should be a visible liquid film on the surface. During
working time, repeatedly wipe and redistribute the product
with the sponge, add more product if necessary. Do not
allow the product to dry (Lithofin Anti-Slip only works as a
liquid). Avoid foam. Continuously check the slip resistance
by moving the sponge across the surface. Stop treatment
when the desired effect is reached.
3. End Treatment: add water and a few drops of Lithofin
Basic Cleaner to the solution on the surface, distribute
immediately and wipe off the surface. Rinse well with clean
water.
Important, Please Note: especially the undiluted product
must not come in contact with sensitive surfaces (polished
limestone, marble, lacquer, wood, carpets, etc.).
Immediately wash off any splashes. Protect metals and
other adjoining areas. The surface to be treated must be
completely clean and free of grease and care product
residues. The surface temperature should be between 10°C
and 25°C during application. Switch off under floor heating.
The surface is permanently altered on a microscopically
